With high quality drinking water more harmony, more energy and better results

That is why each investment in your health and in your well-beeing is an investment regarding your occupational aims and your private future.

GIE-Water-activating-technique

The GIE activator is installed behind the instrument for gauging water into the plumbing for drinking water located in the appartment or the house. It is working simultaneously with the help of 15 different function principles instantly activated by the water pressure after turning on the tap. Being installed the GIE activator needn´t to be maintained at all und offers you for decades drinking water with a high capability of removing toxic substances and waste products from your body. This effect is not achievable by using chemically treated and "dead" tap water. By way of contrast the GIE water is living (shows a biological activity) and it tastes much better than the original tap water.

Installation examples

Installed behind the instrument for gauging water

Simply to install:
In the shower

You can also install it outdoors.

It is also possible to install it sloping with the direction a little bit upwards

You could also install it below the plumbing but it ought to be always directed upwards.

The entrance and the exit of water are marked at the device. Both the exterior run in and out of the water are gauged to 1". With the help of appropiate appliances for reducing the plumbing diameter it is possible to connect the activator to any smaller diameter. Bigger water-pipes require larger scaled GIE-devices. Both cold and hot water can flow through the activator.

Installation instruction with vertical tube

Cut out an appropriate part of the tube.
Mount the 90° connections and the reduction parts if necessary. (The connectors of the activator usually come with 1" diameter).
Connect the hoses to the water tube.
Now connect the activator to the hoses (but not yet tight!) to find out the right position of the clamps for fixing the activator on the wall.
Please watch the direction: Water in: blue, water out: red
Do never bend the hoses!
When putting up the clamps keep distance to the end caps of the activator.
The activator's connectors have to point downwards, whereas the activator can be mounted sloping, as you can see on the fotos above.
After having mounted the clamps and the activator tighten the nuts, but...
... take care that you support the screws on the activator's side with a pipe wrench to avoid twisting of the inner construction of the activator.
Open the water-supply - and the GIE-activator will supply you with living, high quality drinking water.

Please don't forget to include the clamps and the needed length of the hoses in your order.

Printversion